Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
We have several of the SG300 series of switches. All seem to work fine with SNMP.
We have one SG300-28 however that will not response to SNMP requests.
We have:
snmp-server serversnmp-server community READSNMP ro view DefaultSuper
set in the...
Hello,I am setting up QOS for SIP phones on a Cisco 3560.I would like to set up individual ports for QOS, then test the results.On this switch model, it appears that the command to view output queues for port 1 is: show platform port-asic stats enque...
I installed 4 SPA112 units this week for fax machines at a client location. Three worked perfectly, one fails while executing the fax handshake.I updated the firmware to 1.3.1 (003), that did not help.The failing unit is attached to a Fax Server, wh...
Hello,I have a new client site with Polycom IP331 phones and an SF300-24P switch. We are manually setting the VLAN tag on the phones, but it appears to be being overridden by some setting on the switch. I have tried disabling every discovery servic...
Vinod,
I had tried both Default and DefaultSuper in the past. I set it back to Default and tried again, no luck.
I used the show snmp command. That seemed to only show the snmp config settings? Not any kind of traffic?
Thanks.
Bryan Hunt
Marvin,
Thanks for the response.
The switch is remote, so have not been able to do a packet capture off of a mirrored port. But, we can touch the switch via SSH and HTTPS, so I know that it is reachable from our site. And have confirmed that the UD...
Some follow-up on this question:- Apparently our model (and/or firmware) is a little dated. In newer models, the standard:show mls qos interface gigabitEthernet 1/0/1 statisticsdoes show the output/egress queue statistics at the end. Our model/firm...
Dan,I'm leaning more towards a physical issue (like impedance) than an issue with the Asterisk server, mainly because the other two ATAs worked perfectly out of the box without any special settings (even the optimized fax settings). They are all wor...
