3560 Clear port-asic stats

[BRYAN HUNT]

Hello,

I am setting up QOS for SIP phones on a Cisco 3560.

I would like to set up individual ports for QOS, then test the results.

On this switch model, it appears that the command to view output queues for port 1 is: show platform port-asic stats enqueue gi 0/1

This seems to show the frames by queue and threshold.

Before I set QOS on the port and test, I would like to clear those statistics for port 1.  I have been unable to find any command that will clear those stats so I can start with a clean slate.

Can someone enlighten me on how to clear those stats?

Thanks.

Bryan Hunt

[BRYAN HUNT]

Some follow-up on this question:

- Apparently our model (and/or firmware) is a little dated.  In newer models, the standard:

show mls qos interface gigabitEthernet 1/0/1 statistics

does show the output/egress queue statistics at the end.  Our model/firmware does not.

So the

show platform port-asic stats enqueue gi 0/1

command is the only way to see them on our model.

There is no command to clear those stats, a reboot is the only way.

Thanks.

Bryan Hunt