Customer is curerntly running Unity 8.0.3 Voicemail only, running Exchange 2003. They want failover added to the current enviroment. I've been following the install guide found here http://www.cisco.com/en/US/docs/voice_ip_comm/unity/8x/installat...
I'm running ACS 5.2 and I want to setup this up for Machine Authentication against Microsoft's AD Server. I'm finding guides for ACS 3.1 but 5.2 is completely different than 3.1 Could someone please tell me where I can find this guide so I can set...
I have a UCS-C210M2 running verison 1.3(1c). When I boot up the server it says checking memory and then beeps a couple times for the USB Keyboard/Mouse then shows the Cisco Logo. This stays like this for about 30mins and then reboots and does the ...
I have a WLC 6.0, ACS 3.3 and the SSID is setup to use 802.1x with Peap Authentication. The clients are using Windows 7 to connect to wireless. To get the clients connected they have to go into there network properties if the wireless card, c...
I currently have two servers for CER, a pub and a sub. The customer wants to put these two servers at different locations for disaster recovery. I know exactly how to configure a Pub in Sub for CER but I'm wondering what are the network requiremen...
Thanks for everyone's help with this issue. The problem was I was using an Old VGA monitor. When I plugged in a new Flat Screen Monitor then all the options appeared on the screen and I was able to select the Bios and the CIMC via the keyboard. T...
I found the answer to my question in the install Guide. Consider installing the standby server in a physically separate location from the primary server, and on a separate subnet not separated by a WAN link.” Hope this helps someone else in the f...
