Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I ran into a issue recently and I'm wondering if anyone has any insight. Migrating my AC clients to an external Windows DHCP server. no matter the size of the scope, whether its a /27, /24, /22... it will only hand out one address per scope and...
I need to find a way to run a report across all of my access layer switches to tell me how many (percentage or count, anything) ports are configured for .1x vs ports that do not have any .1x configuration. I've made a very basic report with orion to ...
I had my ADSL upgraded at home and its now a pair bonded DSL connection. I refuse to lease the modem through the ISP (Windstream). I currently use a WIC-1ASDL which does not support the bonded pair (Windstream calls it G Bond). I researched some on m...
Good morning,
Forgive me as I am still learning WLC environments. I need to move the physical cabling connecting my WLC from one switch to another. Will that cause the WAPs (mixture of local and flexconnect) to reassociate with the controller and wi...
Hello,I have a question regarding security with end-users using the clientless VPN portal. When the user logs into the portal, does it create a tunnel between their PC and my network or is this only HTTP "screenshot" information being passed through...
If anyone is still watching this thread, can the peer NBMA address be a private IP or does it always need to be public? Not sure how you can get it to show up as a public IP when you issue the "sh dmvpn" command.Sent from Cisco Technical Support iPho...
Sounds good guys, thanks for all the help. I have the tunnel up. The spoke is seeing routes but can't communicate to anything. However, the hub router is able to communicate fine to this new spoke behind an ASA. Any ideas on that? Not sure if its an ...
I'm not a FW person so in having a hard time with this. The DMVPN router is behjnd the ASA, so I will need to do the bi-directional NAT-t but unsure how to configure that properly. I'm an ASDM and I don't know if that's confusing me more than CLI or ...
So I just need to allow those ports from outside to inside on the Asa? Do I need to do any port forwarding or anything?Sent from Cisco Technical Support iPhone App
