Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to determine a problem with flapping interface on a router not showing up in log buffer if Cisco IOS. I've included the config on the switch that pertains to the logging and can't seem to figure what is going on. The SNMP trap is being...
I have a customer that is currently configured to use the same publically routable IP address with a static NAT translation and also in a PAT pool. I'm posting a short blurb of the output I'm seeing in the config. Does anyone know if this is possible...
The interface does not have the capability of letting me hard code the speed/duplex settings. I'm pretty sure it's because of the interface having an SFP in them. The one side came up 1000/Full but was set to auto/auto. I think it just auto detected...
I tried this approach. A license was sent to me via a TAR file but I couldn't get it to install. The license command was not available. I contacted Cisco TAC and they advised me that the the above reference model numbers were not capable of upgradin...
Thank you both. This is just prep work for a new firewall migration. So the interfaces are not connected to anything until Saturday. I was under the impression that once you configured the trunk and allowed the vlans that it was a static configurati...
