About Russell Haney

Russell Haney · 04-28-2015

I am having a problem setting up the ISDN Link with a new SX20 here in Korea. Will the PRI-E1 settings will work here? I have attached the config files

Russell Haney · 08-06-2014

I have a C40 with a 1080p camera as the primary and two 720p cameras daisy chained. My problem is that the two 720p cameras keep going to sleep mode when not being used. So when I use the preset for them to be shown they swing from privacy mode to th...

Russell Haney · 03-05-2014

Is there a relationship between the codec software version and the TC Console version number? I can't get the latest TC Console to work with my C90 on version TC6.3

Russell Haney · 08-25-2013

Recently we began installing the newer C series codecs for the US Army. But we have a couple of issues that we need to know if it is at other DOD sites.1. Using the ISDN Link module we have issues connecting to the DVS-G hub sites since Cisco did not...

Russell Haney · 02-27-2013

I just upgraded a C40 codec to the TC6.0.0 software and now I can't get my self-view camera image on the right screen of a dual video setup. It was there before. I do see the PC image if I push Presentation. before a call and during a call I only get...

Russell Haney · 04-29-2015

Yep, done that. I have a trouble ticket in with the Telco just in case they turned off the service.

Russell Haney · 04-29-2015

Wayne, I will try to get the rest of files. But the Link and codec are paired and talking to each other. The PRI config doesn't give me many options for switch type. I set it for Euro since they use E1 channeling here. The ISDN link is giving me a la...

Russell Haney · 08-20-2014

thanks Wayne and Patrick. I had a chance to go over and reconfigure all the presets and it is working very well now.

Russell Haney · 08-07-2014

To begin with I am using a C90 not a C40. My mistake.The setting in the web page seems to only work for the primary camera. Changing it had no effect on the other two cameras going back to privacy position when another preset is chosen. When we save ...

Russell Haney · 03-24-2014

OK after having to change out the codec and camera I have once again been unable to get TC Console to work. I tried to do a FactoryRest and delete the password to get it to work. But then major problems occurred. Like not being able to control the co...

Member Since	‎02-27-2013 05:47 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	29
Total Helpful Votes Received	2

User Statistics

User Activity

isdn link in korea

C40 with 1080p and 720p cameras

TC Console issues

US Army hub sites

C series TC60 software issues

Yep, done that. I have a

Wayne, I will try to get the

thanks Wayne and Patrick. I

To begin with I am using a

Re: TC Console issues