Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Iam getting below error message while importing devices(using the template) to ACS 5.3 server.
checked the header of the file using text editor.
I tried with the new csv file by copying the contents of the import template. But, no luck.
Please ad...
Hi ,
I am unable to access the webpage of WAAS CM, access to device via SSH is working fine.
Webpage is throwing below error , and alarm for disk00 failure. We are running WAAS CM in virtual environment ((oe-vwaas-esx 5.3.5c)
Not sure if hard disk ...
Hi,We are getting "Certificate is near expiration" alarm on more than 200 WAEs . Instead of deleting the expired certificates manually from each device,how to delete this alarms/certificates on all the devices from WAAS CM ?Please advice..Regards,Am...
Hi,We are getting "Network interface error on WAE -674 ". By doing self-diagnostic test the alarm , the alarm is for Gi 2/0 on the WAE which is down as per WAAS CM.This interface is not in use and the primary-interface for the WAE is Gi 1/0.When I tr...
Hi,We replaced a WAE-474 yesterday. After the installation of the new device, I recovered the running-config for this device from WAAS CM. Unfortunately, SSH service is not enabled on the new device and at the same time telnet is also disabled.The d...
Hi Daniel, Thanks for the info.The interface is shown as SHUTDOWN in WAAS CM and the runn-config for this interface also shows it as SHUTDOWN. Butsh int gi 2/0 | i LinkLink State: Interface is up,line protocol upWe didnot get such alarms for this int...
Hi Daniel,Thanks for the info,The SSH is already enabled for this device as per the settings configured for the device group. But the sh run output doesnot show SSH enabled on the WAE.output from sh run***********************************************...
Hi Daniel,The Cisco WAE 7341 has a DB9 serial port connector for console cable. can you please let me know what type of cable does Cisco ship with a new WAE 7341 . In case if we donot have the standard console cable can we use DB9 to RJ-45 converte...
