Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Experts
Customer would like to utilise ISE Guest Self Registration with Aruba Wireless controller
They currently have Aruba AP345 AP's and controllers 7210 / 7240 running code 8.3.0.7
They already have ISE 2.4
Is there a documented guide for s...
Hi Folks,Has anyone deployed a wireless lan solution for guest access, where wired guests are also tunnelled back to the DMZ anchor controller, whereby these wired clients are then doing CWA to ISE?many thanksJason
For Customer RFP response - A customer would like to authenticate wireless users - which may be on laptops or smart devices (ipad/iphone and similar) and apply an AVC profile to a flexconnect wireless client.But for certain times of the day, then res...
iPSK would be the answer to this.https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/216130-configure-catalyst-9800-wlc-ipsk-with-ci.html
The solutions currently supported in the 9800 rely upon Mac address.If you have ISE, then a non-cisco supported tool such as ipsk manager can work with ise to simplify the Mac address overhead.But, yes, the iPSK feature can work with other radius ser...
Scott / Leo have give some good comments above.
if you have walked around with Ekahau and it's complaining that there's lots of interference, this could be due to the fact that the majority of the AP's are on pwr level 1 and could indeed be Co-channe...
Any reason why you have TPCv2 selected?
I suspect this is why most of your AP's will be at TX power level 1 or 2Typically, TPCv1 is recommended (previously TPCv2 was only advised under TAC guidance)I would suggest moving to TPCv1 and initialise your ...
