Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi : Below is a sample config on rate limitFor your example this could be the configuration ! ! Your access-list defining your internal ! traffic access-list 101 permit ip x.x.x.x y.y.y.y any access-list 102 permit ip a.a.a.a b.b.b.b any . . . access...
Hi: I had question on the working of PAT.I have one Public IP address, I would like to perform PAT. The Firewall is not allowing me. Is there a way to configure PAT with one Public IP address. This Public IP address is also the external interface IP ...
There is a Cisco router 3 Ethernet interfaces connected to 3 different IP networks for instance 172.18.32.80/29(A) , 172.18.32.72/29(B) and 192.168.1.0/24(C). I do not want to run RIP on all three interfaces and I want 192.168.1.0/24 network updated...
Thank youI would like set the delay between the update messages. So for example if the router needs to send 20 update messages to complete the route transfers, i would like to be able to set a delay of 200ms between each update. Also can you set the ...
