Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Consider a IPv4 SP that hosts customers Servers/WebSites. Today this SP has a LAN dedicated to these "SMB" clients, all "promiscuos" on the same LAN. Each customer has one IPv4 address, and can (via PAT) serve more than a physical "backend" Server.Th...
Hello.I need to create a script for a couple of routers.Today, when a WAN link goes down (POS1/0, and a syslog message is generated) the event-manager shuts the LAN interface G0/0 to administrative down:event manager applet monitor-down event syslog ...
Hi, actually it is not that old, since it just happened to me.
In our case the solution was to remove the L3 interface that we had in the same VLAN. It makes absolutelly no sense... but it worked. The interface is configured as access, and there is n...
Hiunfortunately I have just one answer and some new questions...The answer regards question #2, about the decimal.The decimal is given to "interim" releases. These releases are internal on Cisco and are not usually published on CCO (unless they are r...
Hi Jim,thank you very much for your post!You hit the issue...I agree with you, the solution for the "one server" customer is the "connected" subnet, so no further entries are needed there.The issue is in fact for the /64 backend subnets of the other...
