Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,I'm tring to test interoperability between Cisco an Juniper Boxes aboutpseudowire services.Let assume that I've an MPLS backbone, where the label distribution protocol used is RSVP, then MPLS-TE tunnels, I do not want to enable LDP on my back...
Hi guys, I'd like to understand if there are some ways to configure RSVP LSPs without using IGP like ISIS or OSPF, but just with static routing. I've not found a way. Anyone have some ideas? Thank you! and Best Regards, G.
Hi guys,I'd like to understand if there are some ways to configure RSVP LSPs without using IGP like ISIS or OSPF, but just with static routing.I've not found a way.Anyone have some ideas?Thank you!and Best Regards,G.
Hi all,suppose to have one network with OSPF as IGP and PIM-SM for multicast.Suppose that a router (R0) is in a Stub area and know the RP and the Mcast Source with the same default route for RPF check.After that Source start to send traffic, do you t...
Hello Harold,the shortcut is required if you want that every prefix known by the IGP have been installed in the inet.3, but this should not be a must.If everything is known by the peer loopback address (through recursive lookup), the default behaviou...
Hi Guys,thank you for your support, probably I've found something interesting that I'll can check next week.From JunOS command reference:" Enabling LDP over RSVP-Established LSPs in Heterogeneous Networks "Some other vendors use an OSPF metric of 1 f...
