Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, On the BE6K ordering guide (see link below), on the VCS section (page 14) reffers to a VCS ordering guide via a URL Link. http://www.cisco.com/web/partners/downloads/partner/WWChannels/technology/ipc/downloads/be_6000.pdfThat link appears to be b...
Just wandering if this is currently possible:Remote Video Endpoint (Via SIP) =>ISP=> VCSe => VCSc => CUCM => 9971 The idea would be to allow the 9971's (or any Video IP Phone for that matters) to received a video call from the internet via URI. I und...
I have the follwoing issue: Customer wants to migrate their current voice and web collaboration solution. They currently have MeetingPlace Express. Their current migration path is MP 8.5 + Webex. However they want it to be 100% on premises (no webex ...
I have an issue with a 2911 Router w/ CUE. When I run the following command:service-module embbeded-service-engine 0/0 statusI get the following output:CPU FREQUENCY: 500MHzMemory Size: 256MBDisk Size: 0 MBI try to install the unity express software ...
I have an ICT between 2 CCM clusters, below is the topology:CCM1 - 4500SW - Router - MPLS Cloud - Router - Router - CCM2Calls between call manages suddenly stopped working. I realized I cannot ping between call managers; however the call managers can...
I know this is an old post but I have a similar requirement today. The documentation is contradictory at best and people from the BU have told me that the CUCM in BE6K is no different from the one on UC on UCS or BE7K and so long I stick to the limit...
UC500 is not supported with the SPA8800 but configuration is very simple to setup and works fine. See the post below where someone posted a sample config.https://supportforums.cisco.com/thread/2074146
Is this feature available? I found a cached document on the internet that on CME 4.2, SRTP was not available on the UC500.However we are currently on version 8.1 and documentation on the UC500 is not as complete as in other platforms.Has someone impl...
