Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Got a question for how to configure Global (outside) NAT or PAT if the PIX is behind a multihomed (non BGP)router. The 1720 router has connections to two seperate ISPs for WAN redundantancy. My question is if ISP B will not route ISP A IP addresses i...
I currently have a production 3600 Cisco router that has a 8 port async WIC that is not being used which I would like to remove. Can you advice if the unused 8 port Async WIC can be removed without first bringing down the router?
Hello,Is there a current VPN Concentrator 3000 software release that will support VLANs? I would like to pursue removing traffic from the default VLAN but was not sure if the Concentrator series supported that functon.
I support a hub and spoke VPN topology consisting of a VPN 3005 on the hub end and varying IOS routers on the spoke end. For simplicity sake I will refer to the hub as Corp and the remote site in question as Remote. Corp edge routing is done by a 3...
Hey,Got a question regarding DSL setup. We have had a very difficult time getting information from the DSL provider. Specifically, it has always been like pulling teeth to get the correct encapsulation, PVC, and pap/chap username password. Anyone ...
Thanks, I thought about possible doing that and it could be a solution. What if I setup the edge router to re-NAT the traffic coming from the PIX. Would this not work? It would create extra overhead but might work. Just use a route-map on the rou...
