Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have one function site-to-site VPN tunnel on my Cisco 831. I want to add another one using the same external IP address. Is this possible or do I have to start hunting for a second Cisco 831 or a different device which allows multiple site-to-sit...
When offering to an electrician the power requirements are the Amps and Watts simply added together? For example the 3750s require up to 1.2A & 120W. If I need to stack 6 in one closet should I request 7.4A & 720W for a electrical requirements for ...
I would like to block the most popular IM sites, i.e. yahoo, aol, microsoft, etc.. manualy through IP ranges and ports. Does anyone have a link to quick list with this information or have a better standard rule for a PIX 535 running 6.3(3)? We hav...
Any recommendations for a dialup platform other than a 2511 or AS5300 that will allow me to use an ISDN dialin pool from the local telco while have the firewall feature set loaded. I want to be able to map the user's login ID to the service or devic...
I have a 3640 which I configured multiple subinterfaces on a FastEthernet interfaces. I hoping to configure more than 8 subinterfaces allowed on this trunk. Does anyone know the recommended maximum subinterfaces on this 3640 with two Fast Ethernets r...
I am not familiar with sequencing configurations. Do you have an example which would allow me to virtualize the same interface fro two separate end-client peer addresses? For example, once I configurate the crypto map group and apply it to the inte...
I have found best practice is to change the context of the username/password so I knew when the authentication had gone back to local authentication, ACS, or another tacacs+/Radius box. Also, I have always cleared the AAA configuration before reapply...
Don't forget to reverse the regress/ingress order. In other words, ACLs on addressable physical interfaces will work in reverse of a VLAN interfaces ACL. Simply reverse the "access-group xxx (IN/OUT)" statement.Good luckBrian
Thanks....I can't seem to find good information on the AS5400...I'll login and look again for more information to see if there is semi-standard hardware configuration allowing me to configure multi-service management for dialin groups. I was hoping ...
