About waleedmatter

waleedmatter · 08-19-2025

If i configured vstack from two borders and connected the edge-switches dual homed , when i select the lan automation , it will detect the port-channel and configure it as a layer 3 and add the isis configuration or not ? dnac version 2.3.7

waleedmatter · 02-26-2024

I have two ACI fabric site and the Cisco Multisite established between the two spine switches to exchange the VXLAN's so my question if i need to extend vlan x by create new tenanet x and application profile x and new vrf x and epg x , can i make it ...

waleedmatter · 09-27-2023

I have two tenants (two different VRF's) and each one has different EPG's(different BD's and Vlan pool) and the gateway will be the active firewall and physically the active and standby connected to the two borders as vpc my question : - i will ext...

waleedmatter · 03-05-2023

If i have cat 9300 in SDA can i use the extension module (fiber , uplinks) to connect AP's or any user devices or it is used only for the uplinks between the fabric edge switches and the borders

waleedmatter · 06-25-2022

I have DMVPN QOS implemeted in one tunnel associated with one physical ISP and it worked fine between the HUB and spoke , my question there will be new ISP will connect the hub and new tunnel will create it so my question can i use the same group nam...

waleedmatter · 08-25-2025

But how it is working if the pool of the dhcp in global , it should add vrf Guest under the pool ?

waleedmatter · 08-20-2025

It is new implementation and there is no any impact

waleedmatter · 08-20-2025

so i am waiting your answer ,,,

waleedmatter · 08-20-2025

you didnt get my idea,,,,my target to make two border virtual stack to reduce the bgp neighbors if i will make the two broder separated then when i will make the two borders vstack and connected by two uplinks with the edge-switch and make lan automa...

waleedmatter · 08-20-2025

So work-around ,,,can i make virtual stack between two borders and then make lan automation (seed device) and no peer and select the interface which connected to edge-switch then the isis will be pushed to this link and then provisiong the edge-switc...

Member Since	‎08-12-2004 04:57 AM
Date Last Visited	‎08-25-2025 05:14 PM
Posts	69
Total Helpful Votes Received	25

User Statistics

User Activity

SD-Access vstack from two borders

Cisco ACI Multisite (APIC's) NDO

Extend EPG's in two different tenants but with the same outside port

Extension module in Fabric edge SDA

DMVPN QOS in HUB

Re: LAN-VN cant get DHCP from Fusion Router

Re: SD-Access vstack from two borders

Re: SD-Access vstack from two borders

Re: SD-Access vstack from two borders

Re: SD-Access vstack from two borders