Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If i configured vstack from two borders and connected the edge-switches dual homed , when i select the lan automation , it will detect the port-channel and configure it as a layer 3 and add the isis configuration or not ? dnac version 2.3.7
I have two ACI fabric site and the Cisco Multisite established between the two spine switches to exchange the VXLAN's so my question if i need to extend vlan x by create new tenanet x and application profile x and new vrf x and epg x , can i make it ...
I have two tenants (two different VRF's) and each one has different EPG's(different BD's and Vlan pool) and the gateway will be the active firewall and physically the active and standby connected to the two borders as vpc
my question :
- i will ext...
I have DMVPN QOS implemeted in one tunnel associated with one physical ISP and it worked fine between the HUB and spoke , my question there will be new ISP will connect the hub and new tunnel will create it so my question can i use the same group nam...
in ISE , I will create many authorization profile and each one include the specific parameters (VN name, SGT name , Pool name) and this parameters should match the names in the DNA If i have Authorization profile 1 VN ENG SGT HR Pool name 172.16.1.1...
you didnt get my idea,,,,my target to make two border virtual stack to reduce the bgp neighbors if i will make the two broder separated then when i will make the two borders vstack and connected by two uplinks with the edge-switch and make lan automa...
So work-around ,,,can i make virtual stack between two borders and then make lan automation (seed device) and no peer and select the interface which connected to edge-switch then the isis will be pushed to this link and then provisiong the edge-switc...
