Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone, Here is my topology:CCM---Unity Connection[HA]---PIMG---NortelFrom time to time, the PIMG ports are locked and they clear themselves after that. Has anyone expierenced the same thing and how to prevent that from happening?Thanks!
Hi all,Last night, the inside interface on our primary ASA seemed to "hang". It dropped all the packets it received. Because the interface didnt go down, failover didnt happen. Device's info;Cisco Adaptive Security Appliance Software Version 8.2(3)De...
We came across some weird finding when doing a show interface on one of our 3750X switch. (Please see the output below).GigabitEthernet3/0/11 is down, line protocol is down (notconnect) Hardware is Gigabit Ethernet, address is 44d3.ca17.c40b (bia 4...
Can you configure asa firewall to allow anyconnect vpn connection and then allow the annyconnect user traffic to go across vpn tunnel on the same firewall to remote site? Users on local lan can connect to remote site via vpn tunnel but not anyconnect...
Hi all,I have the following on my 6509:Mod Port Model Serial # Versions---- ---- ------------------ ----------- ------------------------------------- 1 10 WS-SVC-WISM-1-K9 XXXXXXXXXXX Hw : 2.2 ...
Hi,We have something very similar: at each branch we a 2800, a 3750 and an ISP's modem. Router connects to ISP's modem and 3750 on both interfaces. 3750 has a link back to core via MPLS. Normally Internet traffic will go out through the modem by a st...
In this document it says the minimum requirement is version 3.2 but the example they use are 2.2 and 2.1:http://www.cisco.com/en/US/products/hw/modules/ps2706/products_tech_note09186a0080a6c202.shtml
