02-15-2012 08:46 AM
Can you configure asa firewall to allow anyconnect vpn connection and then allow the annyconnect user traffic to go across vpn tunnel on the same firewall to remote site? Users on local lan can connect to remote site via vpn tunnel but not anyconnect users.
Thanks
Solved! Go to Solution.
02-15-2012 06:01 PM
Sure, this is a common requirement. You just need to make sure to include the AnyConnect users' address pool in your access list referred to by the cryptomap used in the site-site tunnel.
02-15-2012 06:01 PM
Sure, this is a common requirement. You just need to make sure to include the AnyConnect users' address pool in your access list referred to by the cryptomap used in the site-site tunnel.
02-16-2012 06:36 AM
Thank you!
I found a document for anyone has the same issue:
http://packetpushers.net/cisco-asa-8-38-4-hairpinning-nat-configuration/
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide