Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,We are using ISE v2.2 for radius authentication of endpoints. Everything is working fine. Except in one Switch where Cisco VOIP 3905 is used. These devices are not authenticating with ISE and taking the Data domain instead of voice. By statica...
What is the use of AURA file during DNAC IOS upgradation. what is the procedure to generate the AURA file in DNAC.
What is the procedure to change the proxy ip in DNAC.
At Ap end i Can its learning Half duplex but at switch end i have configured hardcoded Full duplex.
If i connect different AP on same port then i can see at other AP full duplex.
