Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Service-policy input: QoS-policy
Class-map: Class-A (match-any) 55908 packets Match: dscp ef (46) 0 packets, 0 bytes 5 minute rate 0 bps
Class-map: class-default (match-any) 451923 packets Match: any
Does this output means that we have matched 5590...
We are trying to capture user level logs for Cisco AnyConnect client based VPN. I understand that this is covered using the syslog message types in range 7x. However, just want to confirm, if I configure the logging trap informational under logging c...
Getting the below error while configuring dynamic NAT on SVI.
2017 May 23 14:08:08 <Hostname> %AFM-3-AFM_VERIFY_FAIL: Access control policy modification on vlan 50 failed
2017 May 23 14:08:08 <Hostname>last message repeated 7 times
2017 May 23 14:08:...
I took this diagram from Cisco docs(https://supportforums.cisco.com/document/12110341/routing-traffic-between-two-site-site-vpn-tunnels) providing a great explanation for VPN to VPN routing.
I am working on exactly the same scenario, but to provide ...
Hello All,
We are proposing a solution to customer, where we are giving NAT configuration on Cat4506 switch. As I understand from the documentation, that most of the images does not support NAT, but does enterprise services or any other IP related im...
Hey.. Thanks.
I had checked VPN routing for overlapping networks but that was a direct IPSEC between end points. I understand that going by the NAT order of operations, it should not impact even when we are routing between two VPNs but since I did no...
Got it... Thanks.
Just one last thing on this.. I read on Cisco website:
"When shipped with 8-GB DRAM (M-ASR1002X-8 GB), 4 slots are filled with 2 GB each"
So, ideally would this have been shipped with the RAM installed already in the router, or it n...
Thanks for the response. I understand the difference between MC and MAs. I would like to understand the difference between Mobility Agent and Mobility Anchor, as these are the two components identified in Cisco CleanAir design.
