Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all.
I got a switch 2940 and plugged in my 2950 switch but it did not link the port did not signal. I have never had problems with cisco switches, here are the firmware versions for each. And strange not to link to the port the strange thing is th...
Ola pessoal Possuo um roteador 2800 com uma placa com 4FXS e 4 FXO o meu tronco chega na porta fxo e tenho 4 ramais na porta FXS quero ativar o recurso de transferencia de chamada(call transfer) utilizando o seguinte link http://www.cisco.com/c/en/us...
Hi all, I trying settings the follow environment. Exists any tecnology permit the vlans the client 1 go encapsulation into vlan 100 and traffic client 2 into vlan200. I trying follow setting switchport mode dot1q-tunnel I reserarching the 802.1ad an...
Hi all. I trying setting the environment with GEPON and CISCO C3750X, I have the follow topology. The equipment GEPON have interfaces OLT(optical Line Terminator) with port fiber and port gigaethernet. This port is connnected port switch 3750x, port...
Thanks Leo.
Its works. I put the cable cross and it worked perfectly. And what you said 2940 and 2950 do not support MDI / MDIX. I just had to set the duplex to full manual and it worked. Thank you very much
Regards
why are the two gigabitEthernet interface needs to cross? but I still tested with cross and it did not work. A friend told me that he already had a problem with distinct IOS versions that the encapsulation is not compatible, have you heard anything l...
Hi all. I solved the problem, it was my fault. I had a "connection plar" to the actual number and used a dial-peer to direct for FXS, there have set up the "connection plar" straight to the extension and the transfer worked. I'm sorry. Thank you very...
Pessoal resolvi cagada minha eu tinha um "connection plar" para o numero real e usava um dial-peer para jogar para a FXS, ai coloquei o connection plar direto para o ramal e a transferencia funcionou. resolveu me desculpem. Muito obrigado pela ajuda ...
