Hi!,Have you add the user to the right user group in CUCM? Add all suers to Standard CTI Enabled Group and for 69XX users to Standard CTI Allow Control of Phones supporting Rollover Mode group and for 89XX and 99XX add to Standard CTI Allow Control o...

Hi Leroy,see that TANDBERG explanationThe address book used by TMS-2 is only viewed by endpoint registers on TMS2. Other option is to make a cluster with a internal and external TMS.I doný know if this point is supported by cisco.

Leroy,Yes, you can, you can pull from some gatekeeper attached to TMS, If you have your VCS-E regsiter on your TMS2 you can pull it without problems.Other solution, if you have your VCS-E in a DMZ with 2 diferents ip (internal, external) you can regi...

Hi!if you open the rules and the TMS2 can reach VCS-C yes, but it´s no reccomended, The best solution is to use a tex file.Good luck

Did you resolv the problem, i've the same problem between 4.1 and 6.1