Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i have configured H3C S7506E core Switch port channel as below and cisco switch but the link down down.
interface Bridge-Aggregation1 port link-type trunk port trunk permit vlan all port trunk pvid vlan 10 link-aggregation mode dynamic dhcp-snooping ...
NBAR supported on 4500X switches or not? I am attempting to send NBAR2 info to a Solarwinds server using Flexible ... complete NBAR info. Also I am unable to issue the following commands:- show ip nbar version show ip nbar
Hello,
i have a new 3850 Switch and i configured ip ssh ver 2 and all ssh commands but when i access the switch using ssh i got "No matching ciphers found. Client (x.x.x.x) supported ciphers : aes128-cbc,3des-cbc,aes192-cbc,aes256-cbc,rijndael-cbc...
I have Cat 2960G switch i upgraded from xmodem but when i reboot it goes to switch: mode again and everytime i have to issue boot flash:c2960-lanbasek9-mz.122-55.SE11.bin command.
I need the best way to do Latency check ,Throughput test and packet loss test on Cisco ASA.
please share the right way to do and the values which are considered good.
Hi
to enable Unicast RPF the ip verify reverse-path interface interface_name
this can be configure on all interfaces or inside or outside interface only.
From putty SSH working fine but from SecureCRT No
Kindly find the show ip ssh output as well as the running software version.
SSH Enabled - version 2.0
Authentication methods:publickey,keyboard-interactive,password
Authentication Publickey Algor...
from butty SSH working fine but from SecureCRT not connected.
Kindly find the show ip ssh output as well as the running software version.SSH Enabled - version 2.0Authentication methods:publickey,keyboard-interactive,passwordAuthentication Publickey...
