Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, how do I tell what exactly what is causing my CUCM publisher to issue low virtual memory warnings. I tried issuing a few commands, however I need some help understanding what they mean. What is "/home/tomcat/tomcatJlauncherConfig.xml", "/usr/loca...
Hi, I'm new at configuring Etherchannel, I'm a bit puzzled at a few things and have a few questions:1. After applying the commands below within the lab, the gigabit interfaces on switch (CORE A) remain amber color and not green, I don't know what thi...
Hi, is it possible to have a set of DID's mirrored across two states, one site as a hot standby and the other as active? I was told this is not possible however I'm a bit skeptical.NJ212893XXX to 212893XXXXMA212893XXX to 212893XXXXI'm new to the V...
In Call Manager is it possible to see a log of all inbound and outbound calls for a specific directory number or Cisco VoIP Phone?I'm fairly new to Call Manager and need a way to audit certain users to make sure they're not calling certain numbers or...
Hi, I am fairly new to call manager 7, can someone help me configure CUMC to ring directly at 7pm and end at 8am? I have learned how to setup the CUMC device profile and linking the DN to the device profile, everything works on that part, however I ...
So I went out and bought 8 GB of memory for my MCS 7800, however now I'm seeing that it's using 6GB out of the 8GB of memory.Is this normal for everyone else? I don't understand why call manager would need 6GB of memory, that's an insane amount of me...
Hi guys, doing a "show spanning-tree" on each switch gave the following output (below). This output was taken after changing the channel-group mode from "desirable" to "on". What are your throughts on this output, is STP running ok?STP after channel-...
Hi jeye, thank you for your response, I though it could've been spanning-tree, however I'm not too good with spanning-tree, going to research that furture.It's strange, after changing the channel-group mode to on, everything is now working accross al...
Hi Jeff Van Houten, thank you, by changing all the "channel-group interface modes to "on" instead of desirable allowed all the interfaces to go green instead of 1 remaining amber. Most important of all, a single link from any etherchannel can go down...
Hi Javalenc, thank you for your reply. The system is stating there are over 100 records, however when going to tools>cdr analysis and reporting>enter the extension and time period it only returns 100 records. Is there a way to tell CAR to return more...
