Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Looking at CISCO 2900 series data sheet, there is a sentence under "Benifits"The Cisco 2900 Series enables deployment in high speed WAN environments with concurrent services enabled up to 75 MbpsCan someone please explain what does this mean? The int...
Hello, everyone,I ran into a very strange icmp ping issue that I could not seem to undersatand, hope someone can provide a troubleshooting tip on this. The network has been working fine other than the issue listed below, L2L VPN worksfine and all t...
Our ISP is Level3 and we have 100Mpbs Fast E line.However, with various speed testing tools, we never got better that 20Mbps download speed.Upload speed is usually better than download speed.Also, using Level3 suggested testing tool: testmy.net, uplo...
I followed:http://www.cisco.com/en/US/products/hw/routers/ps274/products_configuration_example09186a0080819289.shtmlAnd my VPN connection is established on 2921.However when I successfully connected to the router via VPN, ipfoncfig shows default gat...
The provide reboot their end of switch already.The provider is telling the same story, not seeing any issues! But we purchased 100Mbps line, we get slow download speed no matter what. Thanks for you input.
GigabitEthernet0/0 is up, line protocol is up Hardware is CN Gigabit Ethernet, address is xxxc.111c.xxx0 (biaxxxc.111c.xxx0) Internet address is 4.4.4.250/30 MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec, reliability 255/255, txload 1/255,...
show interface displays that the interface is running Full-duplex, 100Mb/s. The router is directly connected to Level3 demarc point, not rate policies on the interface.
