08-25-2011 11:38 PM - edited 03-07-2019 01:54 AM
I have Cisco 1841 Router, now itz not working, router is Stucked before itz booting, (Actually it is stucked before the Rommon), here is the only message which I can see from the Prompt
System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2006 by cisco Systems, Inc.
PLD version 0x10
GIO ASIC version 0x127
can anyone please tell me a way to solve this problem
ThankYou
Sasith Fernando
08-26-2011 11:58 AM
Sasith,
Have you tried removing the flash memory to see if it gets into rommon?
If you can get there you can then reinsert the flash and try load the IOS again or a newer IOS. I sounds like a corrupted image to me.
Here is how to do it with TFTP from ROMMON:
http://dataplumber.wordpress.com/2007/03/16/loading-ios-image-via-tftp-in-rommon/
Or you can try directly from the serial connection:
http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bfac.shtml
I hope this helps.
Raga
08-27-2011 04:25 PM
I remove the flash card, but the problem is same
same out put is comming
what is this problem ? i searched in Google. but i ddnt get an answer, i dnt know what to do.
however thanx Luis,
08-29-2011 09:42 PM
Sorry, to hear that, I think in this case you would need to open a TAC case. Most likely they will go for the RMA.
09-25-2011 06:13 PM
I am have the same problem with a Cisco 2651 can you tell me if you found a solutation for your problem?
thanks
mark
12-04-2012 10:11 PM
RMA
12-06-2012 06:35 AM
W S H Fernando wrote:
RMA
Cannot RMA old devices outside support contract.
12-06-2012 01:31 PM
Is the fan working?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide