Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Community,I have an issue regarding failover on an Active/Active ASA cluster with some shared interfaces. I have two ASA firewalls running 16 contexts, most "inside" and "outside" interfaces are shared between contexts and each context has at l...
Hello,I'm designing a network containing two 4900M switches, which need to be linked to eachother using two 10Gb links. Instead of using X2 transceivers (X2-10GB-SR). I want to save costs and use the OneX converter (CVR-X2-SFP10G) with the TwinAx cab...
Hello,I'm running LMS version 3.2 on Windows in ACS mode. To access Cisco.com I use a proxy server, this proxy server has access to the Internet, but connections to "inside" servers (like ACS) are not allowed.I've noticed that the HTTP/HTTPs Connecti...
Hello,I'm using an ASA5520 (version 7.2(3)) with RemoteAccess VPN. Client routes are installed in the routing table with Reverse Route Injection and the redistributed with OSPF. A summary route is used to advertise all clients' IP addresses. This pre...
I need to change the hostname on a few switches, so I want to the the Parameterized templates in NetConfig.I've used the following parameter file:<DEVICE NAME = mySwitch><CMDPARAM NAME = hostName><value>mySwitch</value></CMDPARAM></DEVICE>My template...
I have the same issue.
Software: NXOS: version 7.0(3)I4(5)Hardware: cisco Nexus9000 93180YC-EX chassisFEX: N2K-C2232TM-E-10Gswitch(config)# install feature-set fexFEX config is not supported on Tahoeswitch(config)#
Did you get this fixed?
Cisco released interim release 8.2(5.13) on the 18th of September. After installing this version the issue was gone.Interim Release Notes don't mention the BugID though.Big thank you to Paul for providing the correct answer. Small thank you to everyo...
Hello Madhu,I have two ASA5520 firewalls with SSM10 modules in active/standby failover mode. The firewall configuration is synced automatically between the devices, but the does not happen for the IPS modules.I would like a way to ensure the same rul...
OK. Thanks for the heads up. This proves the issue is known and solved by Cisco.Since it is not a serious issue, I will wait for Cisco to release either an interim release of 8.2(5) of maybe 8.2(6).8.2(5) was released on the 23rd of May 2011, which i...
Here's what I've done:First I used Wireshark to capture the hello's on the a non-shared interface. Look's like ASA uses IP protocol 105 to check the interface status of it's peer. I can see packets flowing in both directions. On a shared interface th...
