About KUNAL HANS

KUNAL HANS · 01-29-2013

I get the following error:Router#config tRouter(config)#snmp-server view rttmon ciscoRttMonMIB included %Bad OIDThe same command is accepted on a Cisco 2900 routerRouter#show version Cisco IOS Software, C1900 Software (C1900-UNIVERSALK9-M), Version...

KUNAL HANS · 01-07-2013

The scenario in detail:Customer purchased 4510R+E chassis & redundant SUP7-E's w/ Ent Services(ES) license.Now they wish to install the new SUP 7-E's in their two old 4507R-Eswitches (running SUP6-E currently with IP Base) (1 SUP in each chassis) and...

KUNAL HANS · 10-09-2012

Hi,My scenario is similar to what has been discussed here: https://supportforums.cisco.com/thread/2067691Two WAN interfaces of Cisco 2921 router connected to 2 ISP leased linesStatic NAT entries on router mapped to web/mail/ftp serversNeed to load-ba...

KUNAL HANS · 07-20-2012

Hi,I have to come up with a script to 'shut' a particular interface on a router (3945E running IOS 15.0) when a link goes down and also to 'no shut' it after the link comes back up. This is what I have so far.track 1 ip sla 10 reachabilitydelay down ...

KUNAL HANS · 07-18-2012

Hi,I'm trying to configure Anyconnect SSL RA VPN. I have followed the config guide for 8.4 & 8.6 but can't even get the Anyconnect page to load. I'm pasting the config below. Plz check and let me know what I have missed. Objectives are:1. The user si...

KUNAL HANS · 10-10-2012

Yep, i did that already since I lost all inbound connectivity. I meant for someone to point out any mistakes in my config which was causing this to happen. It seems like a tried and tested config template since it worked for the OP in the thread I re...

KUNAL HANS · 10-09-2012

Would appreciate it if someone can take a look...badly stuck...thx!

KUNAL HANS · 07-20-2012

Woops, yeah should be g0/0 in the syslog msg also. Thx Joseph!

KUNAL HANS · 07-18-2012

Could this be the reason?https://supportforums.cisco.com/docs/DOC-24550Haven't had a chance to test it out yet.

KUNAL HANS · 07-18-2012

Yes, users at Site-B are behind the 5515-X ASA whos config I have posted, so inside to outside. Right now I have applied the following permit rule on the Site-B 5515-X outside interface in inbound direction and I'm able to connect. But not sure if th...

Member Since	‎07-17-2012 02:43 AM
Date Last Visited	‎01-09-2019 12:05 AM
Posts	19
Total Helpful Votes Received	10

User Statistics

User Activity

Error %Bad OID when configuring SNMP on Cisco 1941

Catalyst 4500/SUP7-E license transfer/re-host query

Dual WAN Load-balancing with Static NAT

Interface shut/no shut using ip sla with EEM applet

Need help with ASA 5515-X (8.6) Anyconnect VPN configuration

Re: Dual WAN Load-balancing with Static NAT

Dual WAN Load-balancing with Static NAT

Interface shut/no shut using ip sla with EEM applet

Need help with ASA 5515-X (8.6) Anyconnect VPN configuration

Re: Unable to establish remote access VPN connection from behind