Hello,I just begin WiFi installations and I have some existential questions.I have 5 Cisco 1552-E APs. One of them is wired to LAN and act as RAP, the 4 others are MAP.On each AP, I use 1, 6, 11 channels as 2,4GHz non-overlapping c...
Hello,I have a WLC2500 which controls some 1310 lightweight APs.I've loaded an autonomous IOS on one of the 1310 APs, and configure it as repeater.Repeater is successfully associated with its parent lightweight controlled AP, and r...
Hello,I have a 2901 router as MGCP gateway on the CUCM.When link between router and CUCM fails, SCCP and 3rd party SIP phones register correctly on the 2901.But when SRST finishes and network returns in normal conditions, SIP phone...
Hello,I try to implement SRST feature on a 2901 router. There's already a MGCP link between router and CUCM (8.6) which is OK (FXS port is mounted for analog phone on CUCM).But SRST doesn't work.CUCM config is OK (System => SRST =>...
Hello,I've a problem with my 871W.I can connect to the router by inside interfaces (LAN & WLAN) but not on WAN (Fa4).My client on the WAN is on the same subnet and I can ping 871.Can you tell me what's wrong in my config ?Thank you...
Yes, I've used the Link Calculator, but it gives me 9 APs whereas 4 is very comfortable in Ekahau Pro.Ok for the tip to place RAP in the middle of the install as a star topology, but it is not possible on all sites !What can I do if I need a range o...
Thank you Scott,Sales haven't expected directionnals antennas for 5GHz whereas design guide advice to use it.I have a RAP with 3 MAP hops. All APs are far away from other by 100m (330ft). In these conditions do you think backhaul will be OK with omn...
I agree.So what I have to think about these figures ?http://www.cisco.com/en/US/i/200001-300000/270001-280000/279001-280000/279061.jpghttp://www.cisco.com/image/gif/paws/111902/outdoor-mobi-guide-06.gifIf 5GHz channels are the same to enable AP MESH...
I agree,This is what I do for another client, with 1552 outdoor APs.But in this case, client have already 1310 APs installed in autonomous mode, and some of them are in repeater mode.What I have to do, is to install a WLC2504 controller to pass inst...
WGB is a good way to interconnect a wired network to the lightweight environnement.But what I have far away from lightweight environnement is not a wired network, it is WiFi clients.So if I use WGB, I might have one AP as client of the lightweight en...
