Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a 3750x switch stack. We installed it to replace a failing network infrastructure. Right now, all but a few of the ports are access ports. We have a portchannel setup to connect two offices.All of our access devices are currently on one bi...
I am trying to get a 1811 to update routes on a 3750x. My static routes are being redistributed to the switch fine, however my connected networks are notMy router has Vlan with several subnets attached.interface Vlan1 description $ETH-SW-LAUNCH$$IN...
I have an 1811 with several subnets connected to it.I recently installed a 3750x plant and want to bring my interior routing back to it.All the routing is handled by the 1811 via secondary interfaces on vlan1I have 192 ports, and subnets show up on a...
I have a few routers (2621s and 1811's) connected to two different ISP's. Both ISP's give me ethernet interfaces to their service. One is a Fibre Optic Link and the other is several ASDL lines. On each of the routers I have configured NAT and stati...
I have a 1811 using NAT to get our internal services out to theinternet. I have 2 dns servers on the inside of our network that servepublic queries.I have a class c (provided by my ISP) for my outside interface. I havethe last 11 addresses setup in...
This is something I've been working on recently. We want to move our perimeter routing back to the switch. We have two adjacent class C (not private) and the rest are private networks. These are listed as xxx.xx.xxMy ISP's network is yyy.yyy.yyy.x...
That's what I was getting to I think. Then it would not matter what subnets appear where, it would route them all. Or am I misunderstanding how the L3 routing works on a switch stack?My plan is to use another subnet for the "routing" network. All ...
Fair enough, I will test that with another interface. We are installing a VOIP system (Cisco Call Manager). Each port will have at least 2 vlans on them, one for voice and the other for Data. Will all of our ports need to be configured as trunk po...
