Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good Evening,
I'm trying to setup MPLS across two datacenters, to avoid extending direct Layer 2 to avoid STP loops, but i've ran into an issue if the vlan terminates IP wise on one of the devices as xconnect cannot be configured on an interface with...
Good Evening,
I'm trying to setup MPLS across two datacenters, to avoid extending direct Layer 2 to avoid STP loops, but i've ran into an issue if the vlan terminates IP wise on one of the devices as xconnect cannot be configured on an interface with...
Good Evening,
I'm trying to setup MPLS across two datacenters, to avoid extending direct Layer 2 to avoid STP loops, but i've ran into an issue if the vlan terminates IP wise on one of the devices as xconnect cannot be configured on an interface with...
Hi, I'm currently in the porosses of migrating two 6509 switches from Standalone to VSS but i'm facing some strange issues. As soon as i did the converstion the interfaces of switch 2 (Secondary) are defaulted. What I did then was I manaully edited...
Hi,I would like to ask if its possible to setup a vpn with an ASA with one interface. Kindly see the attached diagram. Basically the Local Subnet (172,16.0.0/24) of the encryption domain of the ASA is located in another segment of the network and for...
The ASA would have a Public IP address on the DMZ Interface. My only concern is how would the same security permit intra-interafce command would work. Assymetric router shouldn't be a problem in this case.
Hi,Thanks for your reply but i'm more conserned regarding VPC keep alive link on a port-channel. All i want to gain is to have the keepalive link with 2 interfaces (for redundancy)ThanksEtienne
Thanks for your answer. Then if i need communication between vlans is it possible to route traffic to the gateway then the gateway routes the traffic back to the router. Basically the gateway is an ASA and i would like to control access with a firewa...
