Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 1702I and need to deploy them in remote parts of the building, without running more cable. I have a POE access port facing the AP, but I'm trying to steal a PCs cable and just plug the PC into the aux port but I can't get an IP when I do tha...
So I have a question about getting remote wireless APs to connect to the WLCs. Here is the basic setup: [AP]---[L3 Switch]---[Router]---[L3 Switch]---[WLC] (running EIGRP between them) I have the 192.168.222.0/24 subnet built on the switch that i...
Let me first start off by thanking anyone who can help me get this figured out So I'm trying to set up a site to site tunnel between two ASA's, but it's going to be used as a backup (since they are already connected by an MPLS cloud). So basically, ...
I am trying to use WCS Calibration and collecting data points using my tablet. I am having a problem where over 80% of the time it says "No data points collected starting from location (x,y)" However, if I stand in that same exact spot and do it eno...
Anyone? I mean, online it says that I can hook things like printers and IP cameras etc. to it, but I don't see mention of a PC. Although, I fail to see the difference...
I'm having similar issues as well. I've been using the 871W for a few years now, and have always been happy. Even up until recently, when I first started with my 50/5mbps service, I could pull 50mbps without a problem. It was glorious. Now, I can bar...
I'd also like to add that I'm having sort of the same problem, but only when under load.I have a 50mbps connection and used to be able to utilize that no problem. Now, when I hit 30mbps, I get packet loss to the 871w, from it to my servers, and I can...
