Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,I ran into this issue, where my stack logs the error every minute or so:%PLATFORM_STACKPOWER-4-PRIO_CONFLICT: Switch 1's power stack has conflicting power prioritiesThis is stack of 5x 3750Xs running c3750e-universalk9-mz.122-58.SE2.bi...
Hello,I have production stack in the following config:Switch Ports Model SW Version SW Image------ ----- ----- ---------- ----------* 1 52 WS-C3750-48P 12.2(25)SEE4 C...
Hello,I have 3750-48PS-S in production and would like to stack it with C3750G-48PS. Both switches are running code: c3750-ipservicesk9-mz.122-50.SE3.bin Please confirm this configuration will work.Thank you,forman
Hello,I have WiFi device (host 10.6.16.21) which needs to connect to remote server (172.25.20.26 on TCP port 3613) over L2L VPN tunnel. I see that the device is attempting connection, but it is being reset:%ASA-6-302014: Teardown TCP connection 2175...
Hello,I have several Aironet 1231 APs most running 12.3(8)JEA software. There are 4 SSIDs on (each in separate VLAN), with only one broadcasting (called pubwifi). The broadcasting one is an open, unencrypted network:dot11 ssid pubwifi vlan 8 auth...
Ok, hope this will save someone time...here's how I fixed that:1. Switch(config)#Stack-power switch 1 - in my case switch 1 reported error standalone - wait 2/3 minutes no standalone2. Checked the logs and now the same error was generated by switch ...
Ok, thank you for verifying this info Sweta.To make sure that the switch in the production remains the master... can I just set higher priority on it and lower priority on the new member? Or should I provision new member on the production switch? Wha...
Ok, after configuring: dot11 mbssidI didn't see mbssid in running config for interface Dot11Radio0 (which should be there), so I re-entered it, but to no avail:sh run int dot11radio0Building configuration...Current configuration : 627 bytes!interface...
Thank you for clarifying this. As you can see, I have very limited knowledge of AP configs. Should I leave this as is?:interface Dot11Radio0 mbssid ### I added that command when I was originally setting the newwifi SSID, it was part o...
