Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, is posturing supported when combine with DAP on the ASA for anyconnect? The issue that I'm having is that the client never gets redirected to the CPP portal to get the posturing module added and Cisco TAC is saying posturing might not be suppo...
Hello, we have a cat 9300 stack in 2 locations and would like to extend the vlans between the 2 which technology do you prefer to run on the cat 9k for this purpose?
Hello, I’ve configured a IPsec tunnel between a remote site ASA and a headend ASA. The remote site ASA has 2 Internet circuits so 2 crypto maps tied to each outside interface. The headend ASA has one internet circuit with one crypto map with 2 peers....
Hello, I will be deploying posturing in ISE soon. We need to posture contractors and internal users. I have some questions: Regarding installing the posture module if the users don't have admin rights. Is there a workaround for this?Can I allow only ...
We implemented this and when we connect and hit the CPP policy, we're getting a cert warning even though we have a public cert on the portal. Do we need a public cert for admin?
I did this recently with an MS410. I had I one running as the distro and I added another one to it. It was interesting, while Meraki support said I will lose the config when I stack them that didn't exactly happen. Here's what I did and what happened...
