Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Any one ran into this issueWe use websense for guest wifi but i dont see requests hitting websense serverconfig is below class-map type inspect match-any test-1 match protocol httppolicy-map type inspect Wifi-test class type inspect test-1 ins...
Hi, Have a question on dual homes FEX'sI have a FEX that's dual homed to 02 Nexus 5K'SLets say my FEX is 150 and if I want to configure port 150/1/1 to vlan 100, do I need to login to both Nexus 5K's and configure the port 150/1/1 to vlan 100?OR Can ...
Hi,Need some clarification with NAT on ASACan we NAT a public IP to two internals IP's on same portExample belowstatic (dmz1,outside) 4.4.4.4 192.168.1.2 netmask 255.255.255.255static (dmz1,outside) 4.4.4.4 192.168.1.3 netmask 255.255.255.255access-l...
Hi,I cannot login to the wlan-ap0 wireless module in a 891 routerI did service-module wlan-ap0 session used Cisco as username and passwordBut it didnt work.Reset the module using the method below and tried the login again but no luckservice-module wl...
Hi,I am using 8.1 on asaThe requirement is use port 80 and 443 on 02 websites using same external ipLooks liek it can be done (on this version atleast)Thanks
Hi,I figured out the issueIt looks like when you do a "service-module wlan-ap0 session" we have to provide the username password that was configured on router.Once you do that you can use Cisco Cisco to login to the wireless moduleThanks
