Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am on a FPW 1150 appliance running ASA software version 9.14(1)10 and for some reason the Certificate to Connection profile is not working. I made a simple mattiching rule that looks for the issuer DC, but i also tried numerous other values. I inst...
Is it possible to change the LWAPP/CAPWAP control frames marking ?
Default all Access Points and WLC send control frames with DSCP CS6 marking.
I need to change this to DSCP CS5 since the MPLS provider (vodafone) strips all CS6 marking and I don't wa...
I have a clean VM installation of DCNM 10.4.1 and cannot get the e-mail forwarding working.
We use a exchange mail server and whitelisted the IP address of DCNM.
Using the test function we don't receive any e-mail and also no message on DCNM.
Is th...
I noticed that ISE is not setting the DSCP value for Radius or any other communication.
On our switches we mark RADIUS with DSCP CS6, but the RADIUS accept messages from the ISE PSN’s use CS0 (0000 0000).
Is there an option to mark this traffic on ...
Can anyody tell me what the power consumption is of this Router, when idle and under pressure..Couldn't find any information about this in the current datasheet.
I tried to send the e-mail to a laptop with Wireshark, but no attempt for DSCM to send a "test" mail.
Eventually I was successful by changing the default DSCN config and used syslog messages up to info level.
As a test I picked a common syslog messag...
Just a question about this fifo qos pre-classification. What kind of QoS will you be able to achive with this ?How do you configure the QoS settings of the protocols ?
