Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm running a Cisco 1941 and need to set a vpn-session-timeout for just the WebVPN users. I've attempted using the following command
hostname(config)# group-policy FirstGroup attributes
hostname(config-group-policy)# vpn-session-timeout {minutes | n...
Hi,I'm working on segmenting my network for users that are members of Finance. These users are distributed among several locations, each site is connected over MPLS Layer 2 network. At Site A I have a VLAN 10 setup with the Finance users at that loca...
Hi all,I am trying to figure out how to FTP to my Prime installation to export reports to SQL Reporting services. I first attempted to change the location under Administration > System Settings > Report but see that it must be local. Now what I think...
Hi, I want to setup a webpage for my guest network (no authentication) users. When the client connects to the open guest network and upon opening a browser they would be directed to a survey that I would like them to take, if they don't want to take ...
I'm running a trial of ISE and I'm attempting to create the authorization profile with the following settings:Name: Posture_RemediationAccess Type: Access_AcceptCommon Tools: Posture Discovery, EnabledPosture Discovery, ACL ACL-POSTURE-REDIRECTThe do...
Thank you for your help on this. I think I knew this in theory and just needed someone to walk through it with me. I now have an ACL on the VLAN 10 interface at Site B that permits 172.16.100.0 0.0.0.255. Implicit deny on everything else. Works.
Since I'm controlling access at Site A via a Firewall, I think what I need is to control access to VLAN 10 at Site B. What I want ultimately is to deny all subnets with the exception of 172.16.1xx.0 at all sites. This is my first site that I am sett...
Ok, so the routing works as I described above. One interesting note is that the loop occurs if no device is attached. Once I connected a laptop to that subnet the loop did not occur. Learn something new every day. At this point my routing is good. No...
Thank you for talking through this. So, I setup the following and when I trace route it loops at the remote site.Site AVLAN 10 - 172.16.100.0/24Firewall (Gateway) - 172.16.100.1Client 1 - 172.16.100.2Site BVLAN 10 - 172.16.121.0/24Router VLAN 10 IP -...
