Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi. Does anyone have any information as to how best to use thin client conmputing within a NAC regulated environment? I wish to implement NAC to secure my laptop/desktop population, but want to know of any ideas when it comes to thin clients and pr...
Hi. Interesting problem. Have AP1200 with 12.2(15)JA1 and dual radio (.a and .b). Auth is with a Cisco ACS 3.2(3), Windows Domain, LEAP and one SSID on a single VLAN. I can always associate with both radios, .a and .b, HOWEVER I can never receive ...
Hi. I currently have about 60 1210 AP's running a and b radios and LEAP is the authentication mechanism for clients. Unfortunately I have been told that I must move my network authenticaiton to use PEAP with TKIP instead of LEAP (they will not even ...
Hi,I am setting up QoS between 2 sites with the following configuration on the local 3724. I am creating a new cos-dscp map (due to our PBX config), then as follows:#mls qos#mls qos map cos-dscp 0 8 16 26 34 46 48 56#access-list 100 permit ip any an...
Hi. As many of you probably have this setup already can i ask the following?I want to use my AP's and WLSE to provide WDS services so I can do site surveys and rogue AP detection etc. BUT I also want to use PEAP with TKIP/WPA, as I have working on ...
Bjorn. I got it all working using this link. I have LEAP configured and b/g-a radios installed. All works rather well. http://www.cisco.com/en/US/customer/products/hw/wireless/ps4570/products_configuration_guide_chapter09186a0080208a6e.html#wp105...
I have this setup and working. Set up an external database connection on the ACS for a RADIUS server (not RSA) and setup your RSA server with the RADIUS shared secret. Check IP connectivity between both,and make sure that the RSA server is the firs...
Possilby remove the L2QVLAN statement from the 176 option in the phone vlan. I assume you have trunk links to each desk. Ensure that the native vlan is the data vlan, and test the trunk port by assigning a PC with addresses statically in each vlan a...
You can just install the aironet drivers from the aironet client install (option is available when you install). This will work with CCX compliant (or aironet extensions) cards. Check if your non-Cisco cards are and this will let you use LEAP with...
