Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Cisco 5508 is new Wireless LAN Controller supporting new 802.11ac Giga bit Wireless. this has been plugged into LAN port of Small-Business Security Appliance SA 520 LAN port (trunk). Default vlan 1 works fine which is for management but data vlan doe...
2 ASAs have a site to site tunnelASA1 local network: 172.23.10.xASA2 local network: 192.168.60.x ASA-1 has also another interface with 192.168.60.x subnet and the remote network for one of its site-to-site tunnels has the same subnet as well. NOW ASA...
Cisco CME 8.6 have SIP trunks connected to provider server as IP Trusted list (not as register SIP trunks) and have internal SIP devices (Apple iphone and ipad) which require registration to this cme as local extensions. Office Telepony connection to...
HOW to configure local and remote ID on Cisco ASA for Aggresive mode IKE ?The ID must have a '@' symbol in it as required by other peer. I coulod not have this symbol in hostname of ASA like mycisco@branch ?do i need to remove the peer IP address fro...
we have hub and spoke topology (multipoint VPN). one of branch site has 2 Wan links; one primary gi0/0 and one secondary dialer0. At the moment tunnel source is gi0/0 and it works fine but during automatic failover tunnel drops be...
Hi Gabrillo,I reset WLC, switch and Firewall to factory default and re-configured. All seems fine.Thanks for your replies and I Marked you reply as Correct answer because you were right from the start; there are no compatibility issues. and also your...
Thank you again for your suggestion. make sense to me. I am working on it but no joy.Could it be something to do with data vlan encryption as this is WLC 5508 and APs are 2702i?Also you mentioned to allow CAPWAP traffic through the firewall. i really...
Hi Gabrillo, Thanks for your reply.Yes, DATA VLAN is another VLAN that you have configured on the WLC. However DHCP is sitting on Small Business SA 520 for this data VLAN. where this DHCP should be sitting ideally? Also interesting point is WLC can p...
Hi Yousaf,Thank you for your suggestion and it really helped me in resolving the issue.For SIP Trunks terminating on CME, the above given command is essiential to disable the default behavior of referin to SIP proxy and now i can transfer incoming ca...
Hi, Thank you for your reply.Current situation:RAM: 786 MBCisco router C2811: 15.1(4) M5 (C2800NM-ADVIPSERVICESK9-M)CME Version 8.6Are you suggesting to upgrade router IOS only or CME verison as well?cheerszeeshan
