Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When trying to connect using the Cisco AnyConnect client (2.5.0.217) is received the following error message: Host Unreachable. However, if I enter my ASA's IP address in my browser, it prompts me to enter my username and passwords, downloads/update...
I'm in need of information on how to configure incoming calls from the PSTN to an FXO port. Should I use the default-destination command, the connection-plar command or the alias command? What does Cisco suggest/recommends?
Yes, my test client has a DNS server configured and I can browse the Internet. However, I only use my ASA's IP as I haven't registered my ASA in DNS. What I find strange and accidentally omitted from my original post is that, if I type my ASA's IP ...
I just purchase this DMP and the firmware it shipped with was 5.1. I accidentally downgraded to 5.0.3 thinking it was 5.3. What are my options to return to 5.1?
