One WLC is serving multiple sites with different QoS requirements. So we have multiple WLAN profiles with the same SSID, L2 policy open. All of them are anchored at the same anchor WLC. There are the same WLAN profiles with the same IDs at the anchor...
How to manage larger amout of FlexConnect APs? Especialy VLAN mapping, which is saved separately in each AP. I would like to have a list of AP-WLAN-VLAN settings. Is there any CLI command (except show run-config) for it? And what about backup of this...
Hi, is it possible to register an APs with no visibility of the management interface? The WLC would have a separate ap-manager interface but in a different vfr then management interface. APs can see the ap-manager interface one but not the management...
New AP models 1600, 2600 and 3600 use one connector for both RF bands. I need the 2,4 band only. Is it possible to use old 2,4GHz wallmount patch antennas for those APs?
Hi everybody,we have a lot of WLANs and AP groups on two WiSM2. Each AP belongs to some non-default AP group. Now I would like to change default WLAN to interface mapping. But change of WLAN to interface mapping on the WLAN configuration page changes...
I have opened it on the TAC. Here is the answer: Actually this scenario has been filed as an enhancement defect under https://tools.cisco.com/bugsearch/bug/CSCub68067/?reffering_site=dumpcr . further explanation on this is that when anchor start to s...
Many thanks I now the basis. The document is dated five years ago and describes the 4.0 SW. My question was if there is any trick or possibility to arrange it under present HW & SW. Simply isolate management service and AP connection service on the W...
Well I can answer to myself. I made a TAC case and found that is a documented SW limitation.see: http://www.cisco.com/en/US/docs/wireless/controller/7.2/configuration/guide/cg_wlan.html#wp1587233 There are two different possibilities:Suppose that the...
