Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,one of my ap541n access points behaves strangly.It returns out of the blue to the default config.This is what the log tells me:Oct 3 05:36:10 err mDNSResponder mDNSPlatformRawTime went backwards by 2138801570 ticks; setting correction factor t...
Hi,I am seeking some help on how to debug my anyconnect setup.For some reason, the webpage that should show me the anyconnect vpn login is showing an ssl error.Is there a way to debug this problem as I have no clue what could cause this error.The cer...
Hi,I have been spending hours of digging on the webpages of cisco to find a ios upgrade guide for my router.For some reason I just can't seem to find the procudure to upgrade this router command line (892FSP)Can anyone point me into the right directi...
HelloI am doubting how I should define my dhcp range in the nat access listMy dhcp range is 10.0.0.0 /22 (255.255.252.0)I know the access-list permint range parameter is 10.0.0.0 0.0.0.255 when the dhcp range would be 10.0.0.0 /24But how do I enter...
Hello,I have two questions where i cannot find the answer to I configured a working anyconnect vpn on a c892fsp router, using windows webdeployment pkgI would like to add the linux and mac pkg too, so those users get it installed when connected to t...
Sick of these sort of issues. I've had it! Cisco just lost a client (university)
Did already changed switches: all HPE Aruba now.
Have some small lan RV325 routers, will remove and replace them.
I hope Cisco looses it's market leading position soo...
For anyone who experiences the same problem => CHECK THE MAX PoE OUTPUT OF PoE SWITCH!! When you are on the limit of the switch PoE power output you may see that the switch seems to receive enough voltage becaus it starts when plugin in the utp cable...
Hardware issue is ruled out. I replaced the access point with another one.Same behaviour.I get the idea that the problem starts when joining the cluster.
