Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I was in ROM mode on my router, trying to perform a password reset on my router, and now it only shows jibberish to the console when I boot the router. e.g. €žøž†ž þ þàžø æfþþþþž þ`þ˜øø€ž`þ`þþ˜øþ†þ†~þ~þ~þø† þ†ž þ þþžø† þþžæžþ†`þfþ þ€ž þfþþþþž þ`þ怘€...
I have a 7921G phone which has been deleted from CM (v.7.1.3), but it still is able to place and receive calls. I had deleted and re-added the phone twice already. I've upgraded the firmware. I have even checked the license utilization in CM. When th...
New blades (module 11 and 13) are recognized by the system, but not powering on. See Below:trd651301#sho modMod Ports Card Type Model Serial No.--- ----- -------------------------------------- ---------------...
I make cappuccinos at my house all the time. I was on a call the other day, and I hit the mute button on my headset, but accidentally got it wrong, and un-muted. I realized my mistake after I grinded the beans, pulled the espresso shots and steamed t...
"I came up with the following work-around/ solution. "
"to allow traffic to pass between the vlans. This will allow traffic across the subnets and allow your devices to communicate. You will not get broadcast traffic, but as long as you're looking f...
Posted this two months ago, does it help you?
I ran into the same problem and I came up with the following work-around/ solution.
Create separate inside networks with the same '100' value for the security-zone, like you normally would on your inside...
All,I ran into the same problem and I came up with the following work-around/ solution. Create separate inside networks with the same '100' value for the security-zone, like you normally would on your inside interface. Set up NAT, dhcpd, etc. for eac...
