Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a pair of 5540 firewalls.Currently secondary is active .2 and primary is in standby .3 mode.The problem is that I am not able to ping from active to standby IP and vice versa.Even though I can ping them both from the local network.I can ping w...
I am not able to authenticate to Windows AD on the network.Users are in Vlan 132Server is in Vlan 128Both the Vlans are configured on the 3850 Switch, inter-vlan routing is enabled.3850 Switch is connected to 3750 Switch (Trunk ports). 3850 Switch VT...
Can we use the same Natted IP address in two different access lists as source.host.
Both are permit statements.
Both the access lists are part of two different IPSec tunnels.
Actually it is already working in one IPSec tunnel and now I want to use ...
We have a Cisco ASA being configured as VPN Any connect for our existing customer, now we want to use it for another customer.
How these new end users are going to authenticate.
Separate pools for different customers.
Hello Vivek,We have already created IPSEC tunnel on one of our test router and it is working fine.As we are doing it for the first time and have to implement in the live enivornment, just want to take all the precaution.Should we build the IPSEC tun...
