Following situation.ASA 8.2 NAT/dns statement:static (inside,outside) tcp interface smtp 192.168.0.1 smtp netmask 255.255.255.255 dnsHow can I reflect this static in 8.3?I only do have the "interface" as the ouside IP!
Is it possible to retrieve following SNMP datas for a ASA running in multiple Context Mode?- overall CPU load- overall Connections- overall usage of physical Interfaces- overall ...Thanks,Peter
After upgrading from CSM 3.2.0 to 3.2.2 SP3 the automated backups from CSM increased significantly.Old: 80 MB/dayNew: 500MB/dayI did not fin any documentation about that.Any Ideas??Thx,Peter
Put the 5505 on the outside network. Configure the 5520 with an additional IF. Connect the 5505 inside to the additional 5520 IF. Use the 5505 for anyconnect.
Hi,to be honest.we have such configs running and working in versions <8.3.static (in,out) tcp interface .... .... dnsThis config does a rewrite of the dns answer but opens only the port defined for NAT.
Issue the sh vpn-sessiondb summary command.you may see a license information, which differs from your SSL-VPN peers in the show version.If you "disable" the anyconnect essential you will fall back to the amount of users shown in the show version for ...
