Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
From the MSE wips-cli (/opt/mse/wips/bin/wips_cli) when i do
wIPS>show alarm list
Key Type Src MAC First Time LastTime Active TimeZone IsServerAlarm ChannelBandWidth ---------------------------------------------------------------------...
I remember in LMS 4.2 there was an inventory change report.
Do you know if there is something similar in Prime 3.1?
I had a problem when i realized that some devices that were added in the Cisco Prime 3.1 were accidentally (?) deleted and i found it...
We are planning to deploy Wireless in our Branch offices (250).
Each office will have a 32 Mbps line with the Central DC
Since currently in each branch office there is a need for only 1 SSID ( with Internet access from Central DC) is there really a ...
We have implemented wireless access by self-service web portal authentication.Components used are:WLC 5508 (7.4.121)Cisco ISE (1.2.1.198)Access points 1608 (flexconnect) In our firewall we see everyday thousands of tcp connections with Source IP Addr...
Is there a way to find in a remote branch the adsl line number in a cisco router 886VA. When giving show controllers vdsl 0 we can see the upload/download speed but there is no information about the line number.We need this information in order to tr...
Hi Flavio
Thanks for responding.
Unfortunately i can't see any alarms in the Alarms and Events\security.
But if i ran a report for WIPS i can see alarms.
Hi
I have created and applied a profile several times but with no result (see attached).
Attached you can see also the NMSP status.
From Prime i can successfully run a report like Adaptive wIPS Alarm Report where i see multiple alarms from the A...
Hi Flavio
Thanks for your post. Attached you can see the Cisco Prime - MSE reachability status and CiscoPrime -WLC NMSP status showing that they are both synced.
I have read somewhere that both the WLC and Cisco Prime should use UTC time setting...
I also face poor perfomance with Prime 3.1.0.0.132.
My installation was Standard with 16 GB RAM.
I have now a total of 24 GB Ram but performance is still very poor.
I am aware that linux uses all available memory so the output of show memory is misle...
Hi Mark
I have already tried this but it is not what i need.
The problem is that I have imported all my devices from an older lms 4.2.
The disadvantage with that is that devices are not weekly discovered so that in case one device is deleted it wil...
