i am receiving the following error while adding a Cisco ipv6 device in prtg server
Sensor does not get response from device. SNMP credentials are wrong or device does not support the required uptime OID (18.104.22.168.22.214.171.124.0) for traffic sensors....
I am receiving this following error in Cisco 3845 router with IOS image c3845-advipservicesk9-mz.124-5b.bin
%IP_VFR-3-SYSTEM_ERROR: Vlan1: IP VFR System failure - Unable to coalesce fragments
Under VLAN 1 i configured the following
I am facing a issues, while using route-map and prefix list while advertising networks to ISP. I have similar setup in other office and it is working without any issues. In this router, all the network mention with network statement in BGP conf...
I have two edge routers each talking EBGP ( ISP -1 and ISP-2) to a different service provider and talking IBGP to each other. i'm receiving full internet routes from both providers.
In this situation each edge router will have to decide...
I have a setup with multi peering with 2 ISPs. I am running iBGP between the edge routers.
For traffic engineering, i am doing partial advertisement on both backbone using route-maps. I have been facing an issue that whenever one of the backbone...
I am taking full routing table from the AS 9498 and then want to match prefixes from certain ASes which the AS 9498 has direct peering so that i can balance outbound traffic on ISP-1 and ISP -2
ip as-path access-list 28 permit ^$ip as-path access-li...
i am idea is to match the prefixes learned via te below access-list
ip as-path access-list 28 permit ^9498_3257_ip as-path access-list 28 permit ^9498_6762_ip as-path access-list 28 permit ^9498_1299_ip as-path access-list 28 permit ^9498_2914_