Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to use SNMP GET interception with 'istable yes'. Ideally, I would like to pass the entire OID to a Tcl script that will then use the table index as an input to alter its behavior in generating the output, which will then be passed as a ...
I've been looking at doing HA on ASA for the first time, and have found a few confusing bits in documentation.One thing I've come across a few times, is the statement that the failover port between firewalls should be cabled to a switch, rather than ...
I'm authenticating L2TPoIPSec VPN users using RADIUS without problems.Rather than using the tunnel-group "address-pool" general-attribute to specify the pool, I would rather have the local pool name pushed by RADIUS.So far, I haven't had any luck. T...
... and I just found:CSCuf90316 - In lanbase intervlan-routing uses 100% software pathFrom your config:License Level: LanbaseLicense Type: PermanentNext reload license Level: Lanbase From my config:License Level: LanbaseLicense Type: PermanentNext re...
I'm troubleshooting an issue right now that's very similar (3850 stack running 3.2.2), and am about to open a TAC case.2x 3850s in a stack.Switch has two SVIs, call them VLAN A and B.Hosts in VLAN A have no PL to hosts in VLAN A, and no PL to both SV...
Ivan,Here's the protocol breakdown from a capture of the "monitor session 1 source cpu queue all rx" SPAN. Sample size is 27.9 sec. Does anything look interesting aside from the ESP (a sample ESP packet is in my previous message)? The level of ...
Ivan,Thanks for your reply. The traffic is only turning up early in the morning. I had already configured an automated process to execute the requested "show platform" commands, so they are attached.I also had an automated process take one minute ...
