Hello,
I need some help configuring a routing scenario below on the ASA Firewalls only between sites A and B as per diagram (see attached. It can be done using BGP or OSPF but need guidance on which is the best and simplest to configure and how it ...
Hi All,
I am having issues with inbound access from network 200.200.10.0.
Outbound traffic from 10.10.10.0 is working fine to 200.200.10.0 via NAT IP 193.50.50.103
I have attached config.
Any ideas ?
Hello,
I have attached a diagram.
I have two sites with dual ISPs one MPLS and other Internet VPN tunnel connecting between them and VPN tunnels to C.D,E,F.
Routing protocol EIGRP for all sites. BGP only running over MPLS and EIGRP on LAN side on...
Hi,
I have a Cisco IOS router and want to setup an IPSec tunnel between myself and client. Unfortunately we both have overlapping 10 network IP addresses.
Is it possible for me to just Nat the IPs on my side or does the client need to Nat as well ?
...
We currently have a collapsed Core design with 6x 6500 Core switches distributed with WAN links to 2 data centers. Cisco 3850 User Switches connected to cores in main building. VM Enclosures and Servers connect directly to 6500 switches at Data Cente...
Hi,
Yes typo I am not showing real IPs here it's 82.82.82.201 on VMware GUI I replaced.
The Peer address is the Nated address as I am hiding 10 network behind the external NAT 193.50.50.103
If I remove the tunnel will complain and come up as MM_NOSTA...