Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, Have a WLC2504 running 8.1.102.0 but have tried this with 8.0 as well. SSID is central switched. The controller is configured IPv6 global enabled, it has a IPv6 management interface in the same VLAN as the clients. The clients depend on rece...
Hello,We have an ASA we've configured with global policy. It's attached to the core switches with two /30 interfaces with OSPF. These interfaces learn equal cost routes to subnets on the core.We seem to be having a symmetry and state issue i.e. Tra...
Hello,I'm struggling to interpret from the manuals whether this is supported on 3.3S:interface GigabitEthernet0/0/0 ip vrf forwarding VPNA ip address 10.8.24.2 255.255.254.0 no ip proxy-arp ip nat insideinterface GigabitEthernet0/0/2 ip vrf forwardin...
Hello,In 12.4(24)T4, I don't seem to have the SNMP detector in Advanced Security; however, it is present in Advanced IP Services.Is this a known pre-requisite? I can't seem to find any documentation or guidance from Feature Navigator that this shoul...
Hello All,Apologies for what must be a basic question but I'm struggling to find a reference for this, is it feasible to establish two FCIP links between the same pair of MDS without a portchannel with all the Ethernet links from both MDS in the same...
False alarm - 8.1.102.0 works fine. It's actually slowing the RA rate down. My router is sending twice a minute but the wireless sees one every 10 minutes. Cheers,Mike
Well, quite, I need to ask them that. The remnants in the MDS configs don't suggest they've ever tried. If they're not portchannelled, is there a risk of a loop (with the same implications as an Ethernet loop) or does FSPF prevent that?As I said, a...
Hello Jaime,Yes, the only caveat was applying it in the right virtual context. After I applied it to the correct interfaces in the right context, ping worked fine. It was covered in this section of the configuration guide:http://www.cisco.com/en/US...
